low cost jets

[jct842]

while out shopping for pdi items this noon I stumbled in to the hardware welding dept. They had a pen style holder with pin vise and 12 bits inside. #52 thru 74. 52= 1.32mm and #74=.57mm $11.95 made usa too. I believe I can make most any jet now. only thing i couldn't find was an air cleaner so will have to head up to a motorcycle shop, and will probably wait till scoot comes. john

[jack]

John That will get ya close and is great for the main jets in most cases but if ya start messing with the pilot jets ya need to get as small as a #80 and can get a set on Ebay.


For instance I just put a #37 pilot in and it equals a #79 bit and it came with a #35 = #80, small very small JR

[jct842]

got the ebay set coming, my set has drills missing in the range of where I need them. my main i drilled out to 117 and it runs better but may be a little too much, may have to solder it shut and try again. I am going to run it this way for a few more miles and see what the plug looks like. any way I feel one can never have too many drill bits especially the small ones

[jack]

Hey jct842 are you going to the STO rally in Eureka Springs in September? If so I'll see ya!! JR

[jct842]

I doubt it, as I age I stay close to home. I would like to get to eureka springs once sometime though. John