|
Post by terrilee on Feb 29, 2012 16:04:33 GMT -5
ok well got the flywheel puller this morning was going to take the old one of the parts scoot so when i got chrissy off i could see if the magento / stator is the same
then i decided to just go ahead and take chrissy's off but since i dont have a impact wrench wheeled her down to my mech {car] got the nut off easy as peeeezy
but my luck the fly wheel puller wont go on more than maybe 1 thread this is the mech doing it
he's like well i can try to force it. NOOOOOOOOOooooooooooooooo
so he tried to clean up the threads on the puller a bit but it just wont screw in more than a thread
YEAAAAAAAAAAAAAAAAAAAAAAA terri
is it really hard to get it on or should it just screw in easy pezzy?? well before we did any damage , we stopped.
Oh and guess what
PIGGERS CANT PEE AGAIN im not playing with that anymore vet at 8 am tomorrow.
LIFE CAN BE SO MUCH FUN
|
|
|
Post by Rebel on Mar 1, 2012 0:07:29 GMT -5
I've only taken one off, don't recall it being that hard to do. I guess if it were mine I'd give it a bit more of a try, do the threads look pretty messed up?
|
|
|
Post by lhumpolick on Apr 24, 2012 23:01:36 GMT -5
I tried the 4 in 1 on 2 fly wheels today the first one was a wildfire 150d it would noy thread on to the flywheel on the 2nd scoot a sunl150 it screed right on but here is the problem i could not pull the fly wheel off with the wrench i used a standard wheel puller with 2 pronds instead and pulled both flywheels what i will do is buy a heat treated long bolt that will replace the x part of the tool
|
|