Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Feb 15, 2012 2:32:09 GMT -5
FEELS LIKE GOING ON 20 YEARS I HAVE BEEN ASKING THIS
WHEN I PUT A LITTLE FUNNEL
(dam upper case!)
n my air vac line and dump seafoam in there,
about 2 thimbles, let it soak on a warm head and latter start motor
and wreck the neighborhood with blue smoke
is that cleaning my plug, piston head and does anyone know how if yes.Attachments:
|
|
|
Post by kz1000st on Feb 15, 2012 7:15:37 GMT -5
No. A good run, about an hour, cleans your plug, head and piston better than soaking the lower end of your bike after the Seafoam leaks down past the rings. The smoke is from whatever is left after that happens.
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Feb 15, 2012 11:38:57 GMT -5
I run a mix of about 2 cap fulls 2 cycle oil 3 cap fulls sea foam per gallon. On top of boron,
as blue front pointed out xingyue engines run rich,
I never get a fouled plug, but i get a darker then most, 5 crank cases of boron later i am burning much less oil, as predicted, which inturn seems to have left the plug cleaner.
Interesting, I had opportunity to use about 7 gallons of hi test, (got a free container) which seems to have had a tendency to gum plug more then regular. i presume this was anti accelerators in hi test gas, may well have been something else not considered, and was slight
normally i run back and forth between reg and medium, about half and half, i have a BBK at 11,000, i want to baby it against pre ignition.
|
|