|
|
Post by sarniarebel on Mar 26, 2011 22:26:17 GMT -5
so i finally got the rim to fit my engine but ran into another little problem, the rim is such a tight fit to the engine case that there inst enough room for me to even get my finger between the rim and case. am i able to fit a tire to the rim and have absolutely 0 tire going past the edge of the rim?
|
|
|
|
Post by Rebel on Mar 27, 2011 1:56:28 GMT -5
I think you need a different rim.
|
|
|
|
Post by sarniarebel on Mar 27, 2011 7:19:51 GMT -5
I think I'm going to try to switch the axels out if they will fit. The fund pool is almost empty for this build.
|
|
jmkjr72
contributing staff
Commander 132nd Northern Cav. Division
Posts: 2,779
|
Post by jmkjr72 on Mar 27, 2011 10:20:28 GMT -5
this is the disadvantege to doing a swap wihtout a complete donor scoot
a pic might hel solve the issue i am assumeig you are talking side clearance and not front to back clearance
|
|
|
|
Post by Rebel on Mar 27, 2011 10:52:23 GMT -5
A skinnier tire might be an option, it would be better to get a rim that is not as wide. Can you exchange it?
|
|
|
|
Post by sarniarebel on Mar 27, 2011 12:03:57 GMT -5
its side clearance, and unfortunately i can not exchange it because it was bought off of e-bay. im just going to try to mount an old tire to the rim and see if it clears it. ill get a pic up in a few
|
|
|
|
Post by Rebel on Mar 27, 2011 18:08:52 GMT -5
The perils of EBay.
|
|
CAN YOU HELP ME OUT MAN,AS i LOST ME JOB DUE TO NOT BEING ABLE TO GET THERE?ANY INF